Asoka PL9920-BBR - Manual (Page 8)

5) Connect the power supply to the Asoka PL9920-BBR’s power port. Then
plug the power supply directly to an AC wall outlet. Wait until the ‘RDY’ LED
flashes with one second interval. (Note: Connect the power supply
directly into an AC wall outlet. Do not plug the power supply to a
power strip or extension cord.)
6) Turn on one or more of the devices on your network that will access the
Internet through the router.
7) All devices connected to the router and powered on will cause the cor-
responding ‘LINK’ light on the front of the router to turn on. Check that all
expected lights are on including the ‘WAN LINK/ACT’ light. Make sure that
the correct type of cabling is used for all ports. See the troubleshooting
guide if a light is not on. See illustration below for reference.
8) Now the necessary hardware setup is complete, and the software setup
of router and the connected computer begins.
Asoka™ PlugLink™ PL Cable/DSL Router Manual
7