Pfister GT49-CB0Y - Manual (Page 5)

E
N
G
L
IS
H
ENGLISH
ENGLISH
MAINTENANCE & CARE
17
18
20
19
17 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (17A). Turn Valves (17B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (17A) by
separating the Aerator Shell (17C), Basket (17D), and Washer (17E). Once parts have
been cleaned, reassemble by reversing steps.
18 HANDLE REMOVAL
Turn off water before proceeding! With valves in closed position, unscrew Fastener
(18A), and Handle Hub (18B) from Valve Stem (18C).
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased your
faucet.
2. When replacement parts are not available, please write or call Price Pfi ster
Consumer Service.
3. Always turn off water and relieve pressure before working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative fi nishes, use only a soft damp cloth to
clean and shine. Use of polish, detergents, abrasive cleaners, organic
solvents or acid may cause damage. Use of other than a soft damp
cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are
not acceptable for public areas or Commercial use. Installation of Said
Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfi ster.com
• Installation Support
• Care and Warranty Information
20 HOSE CONNECTION REMOVAL
Turn off water supplies and relieve pressure before working on your faucet (see
step 2). To detach Hose Assembly (20A), remove Clips (20B) from Valve Bodies (20C)
and pull the End Connectors (20D) from Valve Bodies (20C). Remove Center Connector
(20E) by pushing up on Quick Connect Housing (20F). Holding plastic Collet (20G) in
place, pull down on Quick Connect Housing (20F) until is free from Tube (20H).
19 VALVE CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet (see
step 2). Remove Handles (see step 18), Valve Flange (19B) and Plastic Nut (19C),
unscrew Cartridge Assembly (19A) and inspect. Replace parts as necessary.
5
17E
17D
17C
17A
20C
20F
20D
20A
20E
20D
20B
20G
20F
20H
20B
18A
17B
18B
18C
19C
19B
19A
20C