Anschutz 1700 - Manual (Page 14)

37
•Replace the safety with the signal pin and
spring and make sure that the safety wing
lines up with the firing pin lug and that the
signal pin is properly seated.
•Turn the bolt handle counter-clockwise
and the wing safety clockwise as fas as
they will go. The bolt is now assembled
and cocked.
•With the bolt handle slightly above hori-
zontal replace the bolt in the receiver and
close the bolt.
•The bolt is now cocked and in firing
position. To unclock the bolt lift the bolt
handle as high as it will go, depresse the
trigger as far as it will go and place the
bolt handle down. The bolt is now closed
and uncocked. The signal pin at the rear
of the bolt should not project showing that
the bolt is now uncocked.
Trigger
Warning:
Your ANSCHÜTZ trigger offers you a
variety of individual adjustment possibilities.
Please note that your rifle always must be
unloaded when any adjustment is carried
out.
Please see the adjusting range for the
referring model from the trigger chart. It
might be necessary to remove the stock from
the barreled action for adjustments at the
trigger.
Trigger adjustments must only be carried
out by an authorized gunsmith. Modi-
fications at factory-set triggers might cause
severe injuries or death.
Please also see the chapter „General
handling of rifles and pistols“.