Anschutz 1700 - Manual (Page 18)

41
you with your index finger to the stop and
hold it there until you have slowly released
the rear trigger and it has returned to its
normal position.
•Afterwards slowly release the front trigger
in the same manner.
Note:
In both cases the bolt remains cocked. The
trigger can be cocked again if desired.
Attention:
Exercise the greatest care when performing
the foregoing actions. Practise several times
with an unloaded rifle until you have
thoroughly mastered the procedure and
always ensure that the rifle is pointed in a
safe direction at any time.
After firing, the empty case is ejected by
opening the bolt. A new cartridge is loaded
into the chamber by closing the bolt. Your
rifle is now ready to fire the next round.
Match trigger
1. Trigger weight
Adjust the trigger weight with set screw
No. 10 (silver screw):
•if you turn it to the right (clockwise):
trigger weight is increased (+)
•if you turn it to the left (counter-clockwise):
trigger weight is decreased (-)
Trigger weight and first stage weight
depend on each other with regard to the
mechanic mechanism. If one of them is
changed there will always be a corres-
ponding change of the other as well.
To move trigger cam No. 11:
•lowest position of the trigger cam:
lowest trigger weight
•highest position of the trigger cam:
highest trigger weight
If the trigger weight is to be more than 200 g,
the trigger cam No. 11 must be adjusted to
i u o p a sd f