Yokogawa DAQWORX - Manual (Page 10)

1-3 IM WX103-01E
1
2
3
4
5
Index
Before Us
ng the Software
On the Logger, you can also perform operations such as starting/stopping data
monitoring, displaying the monitor window, pausing the monitor, and starting/stopping
data recording, as well as displaying the Run screen used to monitor the communication
status of the connected MX100s and the status of data monitoring and recording.
The types of monitor windows available are the Trend Monitor that displays the data
using waveforms, the Numeric Monitor that displays the data using instantaneous values,
the Meter Monitor that displays the data using three types of meters, and the Alarm
Monitor that displays the status of alarm occurrences.
• Montor Screen
You can display the waveforms and numerical values of the measured/computed
data, change the display method, start/stop the recording of the measured/computed
data, pause the monitor, manually control the digital output, analog output, and PWM
output, and perform other operations. When the monitor is paused, you can display
the past data and read computed/measured values using cursors.
In addition to the operations described above, you can also save the setup data (project),
print a list of settings, and perform other operations from the menu.
Vewer
You can load the measured/computed data that was recorded (saved) in the past and
carry out the following operations.
• Synchronization
When the data file is opened, the measurement time is corrected based on the time
information of the PC.
• Display waveforms and numeric values
• Display a list of alarms and marks
• Change the display conditions (group assignments, scale, trip point, display color and
other parameters)
• Read the data values using cursors
• Perform statistical computation over an area
• Display and add marks
• Print the displayed waveform and numeric values
• Save or load display conditions
• Display the file information
• Convert data formats (ASCII, Excel, and Lotus)
• Print data (waveforms, numeric values, alarm/marker list, cursor values, statistics over
an area, and computed values)
• Using templates and save
• Join divided CF files
Calbrator
You can connect to the MX100, display the modules that can be calibrated, and carry out
calibration of each measurement range.
1.1 Functonal Overvew of MXLOGGER