Yokogawa DAQWORX - Manual (Page 48)

2-18 IM WX103-01E
Importng Tag Numbers and Tag Comments
You can import just the tag numbers and tag comments from the saved setup data and
replace the current tag numbers and tag comments with the imported information.
From the Fle menu, choose Import Tag. Then, select an MXLOGGER project file (a file
with the .mxe extension) in the Open dialog box.
Only the tag numbers and tag comments are imported.
Select the MXLOGGER project file
(file with .mxe extension) you wish to load
Note
When you carry out the procedure above, the tag numbers and tag comments of computation
channels are also imported.
When Settng the Measurement Condtons for Each Channel Indvdually
Click a desired channel number and enter the settings in the area on the right to set the
measurement conditions.
Measurement channel to be configured
Click here to show or hide the Meas Ch. area
Click the channel number to be configured
To move to the next channel
To move to the previous channel Clicking the slot number here displays the channel settings in the
corresponding module in red
2.4 Settng the Measurement Condtons (Measurement Channel Settngs)