Yokogawa DAQWORX - Manual (Page 97)

4-50 IM WX102-01E
4.25 Setting FUNC Key, and SET Key Operations
(for DC100, and DR only)
Click the SETUP tab and select FUNC Menu, or SET Menu from the SETUP (Basic)
Setting contents box, or select from the menubar Settings > SETUP (Basic) Settings >
and FUNC/FUNC3 Menu, or SET/SET3 Menu.
The below explanation is for the FUNC key. Set key setting works the same.
Select the menu to be displayed by pressing the FUNC key whether in the FUNC menu
or the FUNC3 menu.
The FUNC menu is displayed by pressing the FUNC key at a touch and the FUNC3
menu is displayed by pressing the FUNC key for about 3 seconds continuously.
Select one of the following three options using the radio buttons:
1 FUNC: displayed in the FUNC menu.
2 FUNC3: displayed in the FUNC3 menu.
3 OFF: not displayed in either menu.
Note
[OUTPUT] can be accessed with the SET key. When you select [OUTPUT], you can assign
transmission output channels.