MAHLE RTI TX200 - Manual (Page 5)

Page 4
RECOVERY MODE
Figure 1 shows the recommended connection of the TX200 to an A/C System.
CAUTION...
The hose from the A/C System must be connected to the LIQUID VALVE of the DOT
Cylinder. The Hose from the DOT Cylinder to the External Disposable Filter (EDF) must
be connected to the VAPOR VALVE of the DOT Cylinder. This prevents introduction of
large quantities of liquid refrigerant, oil and acid into the TX200 which could damage the
Compressor.
Do not depend on the colors of the Valve Knobs to indicate Liquid or Vapor. Always check
the embossed printing on the knobs.
The ERC Cylinder must have an Overfill Protection (OFP) Device.
Disconnect Power Cord from power source while connecting the OFP (Overfill Protection)
Device to avoid bodily injury due to electrical shock.
Connect Yellow Cable from TX200 to OFP Device on ERC Cylinder.
Do not force plug into OFP Device. Look at pins in plug and align them with sockets on
OFP Device.
Figure 1 TX200 Connection For Recovery