MAHLE RTI TX200 - Manual (Page 6)

Page 5
Connect TX200 Power Cord to a properly protected, grounded receptacle. Avoid using an
extension cord with the TX200. If necessary, use a good condition, UL listed, 3-wire
grounded, #14 AWG extension cord of the shortest possible length.
The TX200 is now ready to recover refrigerant.
Press the top of the ON/OFF Switch. The switch will illuminate to indicate that power is on.
The COMPRESSOR ON Light will illuminate and the TX200 will begin recovering
refrigerant.
The CYLINDER FULL Light will illuminate if the ERC Cylinder fills to capacity.
The TX200 will recover refrigerant until a vacuum is sensed. The Compressor will turn off
and the Compressor-On Light will turn off.
! ! ! ! DO NOT TURN THE TX200 OFF OR DISCONNECT HOSES ! ! ! !
A small quantity of Liquid refrigerant will probably remain in the A/C System. This liquid
will vaporize (boil up) and increase pressure in the system as components again warm to
ambient temperature.
Figure 2 TX200 Control Panel