MAHLE RTI ATX-3 - Manual (Page 5)

Page 4
560
-8041
4-
00
KEYPAD FUNCTIONS
The ATX-3 is an automatic transmission fluid exchanger featuring state-of-the-art electronic controls
with digital weight scales measuring the automatic transmission fluid coming into and going out of the
machine. Operation of the ATX-3 is intuitive and very easy to master.
Transmission fluid is removed from vehicle and filtered before collecting in the ATX-3
used fluid tank. When the procedure is complete, the ATX-3 buzzer will sound
continuously until the stop button is pressed. Refer to page 8 for cooler mode and
page 12 for dipstick mode for complete instructions.
Filters and exchanges the used transmission fluid in the vehicle for new from the ATX-
3. The procedure is complete when the buzzer sounds continuously until the stop
button is pressed. Refer to page 9 for cooler mode and page 12 for dipstick mode for
complete instructions.
Transmission fluid is emptied completely from the new fluid tank inside the ATX-3. It
can be stored in a bulk container for later use. This procedure is performed if a
change in transmission fluid types is required. The ATX-3 buzzer will sound
continuously until the stop button is pushed when procedure is complete. Refer to
page 14 for complete instructions.
Transmission fluid is emptied completely from the used fluid tank inside the ATX-3
into a bulk used tank for proper disposal. This procedure is performed when the used
fluid tank is full or the used fluid tank capacity is not sufficient to perform selected
exchange. The ATX-3 buzzer will sound continuously until the stop button is pushed
when procedure is complete. Refer to page 14 for complete instructions.