MAHLE RTI ATX-3 - Manual (Page 6)

Page 5
KEYPAD FUNCTIONS
Used after the exchange process if fluid level is too high on the transmission dipstick.
Removes ½ quart of fluid from the transmission. The ATX-3 buzzer will sound
continuously until the stop button is pushed when procedure is complete. Refer to
page 9 for cooler mode and page 13 for dipstick mode for complete instructions.
Used after the exchange process if fluid level is too low on the transmission dipstick.
Adds ½ quart of transmission fluid to the transmission from the ATX-3 new fluid tank.
The ATX-3 buzzer will sound continuously until the stop button is pushed when
procedure is complete. Refer to page 9 for cooler mode and page 13 for dipstick
mode for complete instructions.
Stops any procedure the moment it is pushed, also used at the end of a procedure to
acknowledge completion of process and turn buzzer off.
Illuminates when battery connection is backwards.
Illuminates when the used tank is too full or flashes when the capacity remaining is
less than exchange amount selected. The EMPTY Used procedure must be run to
continue operation of the ATX-3.
Illuminates when the new fluid tank is empty or flashes when the new fluid level is less
than the selected exchange amount. The operator must add fluid to the new fluid tank
of the ATX-3 through the fill port.
Illuminates when the vehicle engine is running and connected properly to the ATX-3.
Illuminates when the selected process is complete. The buzzer will sound
continuously when this is illuminated.
The ATX-3 provides two modes of fluid exchange - Cooler or dipstick mode. The
mode is selected using these buttons when the ATX-3 is powered up. During dipstick
mode, the start engine button is pressed at a specified step.
Two LED readouts display the amount of fluid in the New and Used fluid tanks and
give realtime readouts as the different procedures run.
Caution: Always use fingers to operate keypad. Use of sharp objects will cause damage
and void the warranty.