MAHLE RTI MCX-2F (Rev C) - Manual (Page 12)

Page 11
Adapters
Green Hose
TES T & O VER FLO W
LOW ER RAD IATO R EM PTY WA STE TA NK
EMP TY W AST E TA NK
FILL RAD IATO R & O VER FLO W
EXC HAN GE CO OLA NT O R
LOW ER RAD IATO R & O VER FLO W
SYS TEM VA CUU M
OFF
OFF & O VER FLO W
FILL RAD IATO R
EXC HAN GE C OO LAN T
SYS TEM PRE SSU RE
OFF
Radiator
Black Hose
Radiator
Hose
EM PTY WA STE TAN K
OFF
SYS TEM PR ESS URE
EXC HAN GE C OO LAN T
TES T
FILL RA DIA TOR
& O VER FLO W
EM PTY WA STE TA NK
LOW ER R ADIA
TOR
& O VER FLO W
Overflow
Water
Pump
Step
Adapter
Hose
OFF
OFF
SYS TEM VAC UUM
& O VER FLO W
LOW ER R ADIA TOR
EXC HAN GE C
OO LAN T O R
FILL RA DIA TOR & O VER FLO W
Core
Engine
Block Heater
If the pump is running and the new coolant level does not go down:
Try reversing the connections of the green and black hoses.
COOLANT REPLACEMENT
Once the MCX-2F is connected as described on the preceding pages it is ready to
replace the old coolant with new coolant.
Scales for the tank levels are
graduated in quarts and liters
1 Gallon = 4 Quarts.
1. Determine the capacity and type of coolant for the vehicle cooling system. Refer to
the vehicle Owner’s Manual.
2. Make sure the New Coolant Tank (left slot on front) is filled with the correct coolant
and at a level higher than the amount required to fill the coolant system to full
capacity.
3. Check the Waste Tank (right slot on front) to make sure the level is low enough to
accept the full capacity of coolant in the vehicle cooling system.
4. Turn both valves on front of MCX-2F to EXCHANGE.
5. Turn control valve to EXCHANGE COOLANT.
6. Press the top of EXCHANGE COOLANT OR FILL RADIATOR & OVERFLOW
selector switch to turn on the pump.
7. Watch the level of coolant as it lowers in the New Coolant Tank. Press the bottom
of the EXCHANGE COOLANT OR FILL RADIATOR & OVERFLOW selector switch
when it reaches the correct level. This will stop the transfer of coolant.