MAHLE RTI MCX-2F (Rev C) - Manual (Page 5)

Page 4
New Coolant Tank
Coupler
Quick
Green Hose
OFF
OFF
OFF TES T
SYS TEM VA CUU M
SYS TEM PR ESS URE
FILL RA DIAT OR & O VER FLO W
EXC HAN GE C OOL ANT
EMP TY W AST E TA NK
LO WER RA DIAT OR & O VER FLO W
& O VER FLO W
LOW ER R ADIA TOR
EXC HAN GE C OO LAN T O R
FILL RAD IATO R & O VER FLO W
EM PTY WA STE TA NK
Black Hose
Green Hose
Tank Cap & Plug
(Small)
New Coolant
SET UP
The MCX-2F has two tanks (plus an extra New Coolant Tank) which are installed and
connected from the rear. Quick connect couplers are mounted on the hoses which
connect these tanks to the MCX-2F. A green hose connects to the New Coolant Tank
(right side) and a black hose connects to the Waste Tank (left side). The small
diameter black drain hose must be inserted into the hole in the cap of the Waste Tank.
1. Slide the New Coolant Tank to the rear and sit it on the floor.
2. Remove the tank cap and fill the tank with new coolant and water in the
proportions specified by the coolant supplier. The tank can be disconnected
and moved to a bulk coolant storage area for filling if desired. A plug is provided
on the cap to prevent spillage during transport.
3. Replace the tank cap and position the tank in the MCX-2F. Make sure the
green hose is securely connected. Slide the tank to the front so the liquid level
can be seen through the front panel slot.
4. Make sure the plugs are removed from the caps on the Waste Tank and
the New Coolant Tank. This is required for venting the tanks during
operation. The small diameter black drain hose must be inserted into the
hole in the cap of the Waste Tank.
5. Fasten the clips on the tank strap to secure the tanks in the MCX-2F.