MAHLE RTI MCX-2F (Rev C) - Manual (Page 7)

Page 6
SYS
TEM PR ESS URE
OFF
EXC HAN
GE C
OO LAN T
Clear Hose
Green Hose
Black Hose
EM PTY W AST E TA NK
OFF
EM PTY WA STE TAN K
LO WE R R ADIA TOR & O VER FLO W
& O VER FLO W
LOW ER R ADIA TO R
OFF
OFF
SYS TEM VAC UUM
EXC HAN GE CO OLA NT O R
FILL RAD IATO R & OV ERF LOW
TES T
FILL RAD IATO R & O VER FLO W
SYS TEM PR ESS URE
EXC HAN GE C OOL ANT
Radiator
& O VER FLO W
FILL
RA DIA TOR
& O VER
FLO W
LOW ER R
ADIA
TOR EM PTY WA STE TA NK
TES T
Overflow
Radiator
Hose
Water
Pump
SYS TEM VA CUU M
EM PTY WA STE TA NK
FILL RA DIA TOR
& O VER FLO W
EXC HAN GE C
OO LAN T O R
OFF
OFF
& O VER FLO W
LOW
ER R
ADIA TO R
Heater
Core
Block
Engine
RELIEVING RADIATOR PRESSURE
WARNING: Coolant in the vehicle cooling system may be extremely hot and
under great pressure. Wear safety glasses and use protective
clothing and gloves. Use extreme caution when removing radiator
cap and hoses.
NOTE: The MCX-2F does not need to be connected to power for the following.
The MCX-2F will relieve the pressure in a hot-car radiator by drawing a vacuum on the
overflow port on the radiator cap.
Shop air (55 to 100 PSI), connected to the rear port of the MCX-2F causes a vacuum
to be pulled on the small diameter clear hose, also connected to the rear. This clear
hose is connected to the overflow port on the radiator cap as shown above.
The system Vacuum Gauge on the MCX-2F control panel indicates the vacuum level
which will increase until the radiator cap opens and relieves the pressure. As the
pressure releases a small amount of coolant will be seen flowing in the clear hose.
When the pressure has been relieved, the radiator cap will again close and the vacuum
level will increase and become steady on the gauge.
The radiator cap can now be slowly and carefully removed.