Brocade ICX 7750 Hardware Installation Guide - Manual (Page 33)

Brocade ICX 7750 Hardware Installation Guide 23
53-1003084-01
2
Attaching a PC or terminal
VORSICHT
Für die DC-Eingangsschaltung an das System, stellen Sie sicher, gibt es eine
20-Ampere-Sicherung von mindestens 60 VDC, Doppel-Pole, am Eingang Klemme an die
Stromversorgung. Die Eingangsschaltung zum Anschluß an das Produkt sollte Kupferdraht, 12
AWG (3.31 mm2), markierte VW-1, und bewertet mindestens 90° C Eingestellt werden.
MISE EN GARDE
Pour le circuit d'alimentation à courant continu (C.C.), il faut s'assurer de la présence d'un
disjoncteur de 20 Ampères, minimum 60 V C.C, double coupure sur l'entrée vers le block
d'alimentation. Les câbles d'alimentation utilisés pour le produit doivent être en cuivre d'une
capacité de 12 AWG (ou 3.31mm2), marqués VW-1 et classés à 90 degrés celsius.
Attaching a PC or terminal
To assign an IP address, you must have access to the command-line interface (CLI). The CLI is a
text-based interface that can be accessed through a direct serial connection to the device and
through Telnet connections. The CLI is described in detail in the FastIron Ethernet Switch
Administration Guide.
Access the CLI by connecting to the console port. After you assign an IP address, you can access
the system through Telnet, or Brocade Network Advisor.
Use the following steps to attach a management station to the console port:
1. Connect a PC or terminal to the console management port on the front of the Brocade ICX
7750 using the mini-USB serial console port cable (Part number 50-1000122-01).
For port pinout information for the mini-USB serial console port, refer to “Pinouts and signaling”
on page 51“.
NOTE
You must run a terminal emulation program on the PC.
2. Launch the terminal emulation program and set the following session parameters:
• Baud: 9600 bps
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
The console serial communication port serves as a connection point for management by a PC.
Connecting to the management port
The Gigabit Ethernet management port (RJ-45) on the Brocade ICX 7750 rear panel provides an
out-of-band network connection to the device. After you assign an IP address, you can access the
Brocade ICX 7750 from anywhere in the attached network using Telnet, a web browser, or other
network management tools, such as Brocade Network Advisor. To prevent unauthorized access,
Brocade recommends that the management port only be connected to a secure private network.