Brocade Fixed Rack Mount Kit Installation Procedure (Supporting VA-40FC, VDX 6710-54, VDX 6720-24, VDX 6720-60, VDX 6730-32, and VDX 6730-76) - Manual (Page 10)

10 of 12 Fixed Rack Mount Kit Installation Procedure
53-1001274-06
Installing the switch in the rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack, as shown in Figure 3 , providing temporary support under the switch until the rail
kit is secured to the rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts.
3. Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 3 Positioning the switch in the rack
NOTE
The figure above is shown with a recessed mounting configuration on the left and a flush mounting configuration on
the right. You can select either mounting option.
1 Bracket, front left 3 Retainer nut, 10-32
2 Bracket, front right 4 Screw, 10-32 x 5/8-in., panhead Phillips