Brocade Fixed Rack Mount Kit Installation Procedure (Supporting VA-40FC, VDX 6710-54, VDX 6720-24, VDX 6720-60, VDX 6730-32, and VDX 6730-76) - Manual (Page 9)

Fixed Rack Mount Kit Installation Procedure 9 of 12
53-1001274-06
Attaching the front brackets
Complete the following steps to attach the front brackets to the switch.
1. Position the right front bracket with the flat side against the right side of the switch, as shown in Figure 2 .
2. Insert two 8-32 x 5/16-in. screws into one of the pairs of vertically aligned holes in the bracket and then into the
pair of holes on the side of the switch. To install the switch in a recessed position in the rack, use the bracket
holes that are set back from the end of the bracket.
3. Insert additional 8-32 x 5/16-in. screws through the holes in the bracket and into the corresponding holes in the
switch. The number of screws may vary depending on the switch model.
4. Repeat step 1 through step 3 to attach the left front bracket to the left side of the switch.
5. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
FIGURE 2 Attaching the front bracket
1 Bracket, front right
2 Screw, 8-32 x 5/16-in., panhead Phillips