Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure - Manual (Page 4)

4 of 8 Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure
Publication Number: 53-1002668-01
Parts list
The following parts list refers to items illustrated in Figure 1 on page 4.
FIGURE 1 Mid-mount rack kit
ATTENTION
This hardware kit is a universal kit, and some hardware will not be used in this installation.
Install the rack hardware
1. Unpack the rack kit.
2. Ensure that there is 15U of space for the VDX 8770-8.
3. Align the holes in the saddle with the holes on the mounting posts and attach the saddle using six 10-32 x .63
pan head screws that were provided in the kit (three screws on each post, in the two top holes and one bottom
hole). The saddle attaches to the rear of the posts. See
Figure 2 .
TABLE 1 Items supplied with the Brocade VDX 8770-8 flush or mid-mount rack kit
Description
Saddle
10-32 x .63 in.(1.60 cm) Phillips screws with square cone washers
10-32 x .312 in.(.79 cm) Phillips screws
1 Saddle 3 10-32 x .312 in.(.79 cm) Phillips screws (16)
2 10-32 x .63 in.(1.60 cm) Phillips screws with square
cone washers (12)