Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure - Manual (Page 7)

Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure 7 of 8
Publication Number: 53-1002668-01
3. Slide the switch onto the saddle and into the rack. Refer to Figure 4 .
FIGURE 4 VDX 8770-8 mid-mount installed in a two-post rack
4. Secure the switch to the posts using six 10-32 screws with square-cone washers, three screws for each
mounting bracket attached to the switch. Tighten the screws to 32 in-lb (36.86 cm-kg)
NOTE
Screws, clip nuts, and retainer nuts for mounting the switch to the rack are located in the switch hardware
accessory kit.
1 Screw locations (opposite side similar)