Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure - Manual (Page 5)

Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure 5 of 8
Publication Number: 53-1002668-01
NOTE
The screws must be inserted from the rear of the rack.
FIGURE 2 Saddle installed in the rack (screws inserted from the rear)
Mounting the switch in a flush configuration
1. Be sure that the rack ears are firmly mounted along the front edge of each side of the switch.
2. Maneuver the lift with the switch in front of the rack and adjust the height to match the saddle.
3. Slide the switch onto the saddle and into the rack. See Figure 3 .
1 Screw locations for mounting saddle (both sides similar) - screw must be inserted from the rear of the rack