Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) User Manual
Multi-service ironware, Multicast configuration guide
Advertising
Table of contents
Document Outline
- Copyright © 2013 Brocade Communications Systems, Inc. All Rights Reserved.
- Brocade Communications Systems, Incorporated
- Document History
- About This Document
- Configuring IP Multicast Protocols
- Overview of IP multicasting
- Changing global IP multicast parameters
- Concurrent support for multicast routing and snooping
- Defining the maximum number of DVMRP cache entries
- Defining the maximum number of DVMRP routes
- Defining the maximum number of PIM cache entries
- Defining the maximum number of multicast VRF CAM entries
- Defining the maximum number of IGMP group addresses
- Changing IGMP V1 and V2 parameters
- Mtrace overview
- Support for Multicast Multi-VRF
- Adding an interface to a multicast group
- Multicast non-stop routing
- Passive Multicast Route Insertion (PMRI)
- IP multicast boundaries
- PIM Dense
- Initiating PIM multicasts on a network
- Pruning a multicast tree
- Grafts to a multicast tree
- PIM DM versions
- Configuring PIM DM
- Failover time in a multi-path topology
- Modifying the TTL threshold
- Configuring a DR priority
- Displaying basic PIM Dense configuration information
- Displaying all multicast cache entries in a pruned state
- Displaying all multicast cache entries
- Multicast PIM neighbor filter
- PIM Sparse
- Multicast Outgoing Interface (OIF) list optimization
- Configuring Multicast Source Discovery Protocol (MSDP)
- Configuring MSDP mesh groups
- MSDP Anycast RP
- PIM Anycast RP
- DVMRP overview
- Configuring DVMRP
- Configuring a static multicast route
- IGMP V3
- IP multicast traffic reduction
- Commands
- Configuring IPv6 Multicast Features
- IPv6 PIM Sparse
- PIM Sparse router types
- RP paths and SPT paths
- RFC 3513 and RFC 4007 compliance for IPv6 multicast scope-based forwarding
- Configuring PIM Sparse
- IPv6 PIM-Sparse mode
- Configuring IPv6 PIM-SM on a virtual routing interface
- Enabling IPv6 PIM-SM for a specified VRF
- Configuring BSRs
- Route selection precedence for multicast
- Enabling Source-specific Multicast
- Configuring a DR priority
- Passive Multicast Route Insertion
- Displaying PIM Sparse configuration information and statistics
- Clearing the IPv6 PIM forwarding cache
- Clearing the IPv6 PIM message counters
- Updating PIM Sparse forwarding entries with a new RP configuration
- Clearing the IPv6 PIM traffic
- Setting the maximum number of IPv6 multicast routes supported
- Defining the maximum number of IPv6 PIM cache entries
- Defining the maximum number of IPv6 multicast VRF CAM entries for all VRFs
- PIM Anycast RP
- Multicast Listener Discovery and source-specific multicast protocols
- IPv6 Multicast Listener Discovery snooping
- IPv6 PIM Sparse