Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 156)

144 Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Commands
1
The following example shows how to clear the IGMP flows for a specific group and retain reports for
other groups.
Syntax: clear ip multicast vlan vlan-id all | group group-id
The all parameter clears the learned flows for all groups.
The group group-id parameter clears the flows for the specified group but does not clear the flows
for other groups.
Commands
The following commands support the features described in this chapter:
• multicast-routing load-sharing
• multicast-routing load-sharing rebalance
• pim neighbor-filter
• show ip|ipv6 pim interface
• rpf shortcut
Brocade# show ip multicast
IP multicast is enabled - Active
VLAN ID 1
Active 192.168.2.30 Router Ports 4/13
Multicast Group: 239.255.162.5, Port: 4/4 4/13
Multicast Group: 239.255.162.4, Port: 4/10 4/13
Brocade# clear ip multicast vlan 1 group 239.255.162.5
Brocade# show ip multicast
IP multicast is enabled - Active
VLAN ID 1
Active 192.168.2.30 Router Ports 4/13
Multicast Group: 239.255.162.4, Port: 4/10 4/13