Brocade FCoE Switch Module for IBM BladeCenter Installation and User’s Guide User Manual
Page 11
xi
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM
®
Part Number 33F8354 or an equivalent type
battery recommended by the manufacturer. If your system has a module containing a lithium
battery, replace it with only the same module type made by the same manufacturer. The battery
contains lithium and can explode if not properly used, handled, or disposed of.
Do not:
•
Throw or immerse into water
•
Heat to more than 100°
C (212° F)
•
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Statement 3:
•
Never turn on any equipment when there is evidence of fire, water, or
structural damage.
•
Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
•
Connect and disconnect cables as described in the following table
when installing, moving, or opening covers on this product or attached
devices.
To Connect:
To Disconnect:
1. Turn everything OFF.
1. Turn everything OFF.
2. First, attach all cables to devices.
2. First, remove power cords from outlet.
3. Attach signal cables to connectors..
3. Remove signal cables from
connectors.
4. Attach power cords to outlet.
4. Remove all cables from devices.
5. Turn device ON