Brocade FC16-64 Port Blade QuickStart Guide (Supporting DCX 8510-4 and DCX 8510-8 with Fabric OS 7.3.0 and above) - Manual (Page 11)

For an example of how a blade needs to be oriented in 8510-8 chassis, refer to the following
illustration.
FIGURE 6 Insertion of the FC16-64 port blade in DCX 8510-8
3. Adjust the ejectors to the open position by rotating them toward the center of the blade, align the
flat side of the blade inside the upper and lower rail guides in the slot, and slide the blade into the
slot until it is firmly seated.
4. Close the ejectors by rotating them away from the center of the blade.
5. Tighten the thumbscrews using the Phillips screwdriver.
Attaching cables to the blade
To attach the QSFP connector end of the QSFP cable to the FC16-64 blade, complete the following
steps.
Attaching cables to the blade
FC16-64 Port Blade QuickStart Guide 9
53-1003197-01