Brocade Virtual ADX Installation and Deployment Guide (Supporting ADX v03.1.00) - Manual (Page 21)

Enter root at the prompt. You do not require a password for logging in at this point. You should see
the following prompt.
Virtual ADX>
Execute the following commands.
Virtual ADX>enable
Virtual ADX#serial-number ser_num
Virtual ADX#show serial-number
The output of the second command should be the value of the ser_num you entered.
NOTE
The serial number is also your entitlement information for support. Please make a note of it for your
records. You will receive this information from Brocade at the time of order fulfillment.
NOTE
By default there is no password and you are logged in as root. Brocade recommends that you set a
password as soon as possible.
NOTE
You will need to enter Ctrl-Alt to get cursor control back from the vSphere console.
Additional interfaces
You can add up to five additional interfaces to the default configuration (four interfaces).
Adding and removing interfaces
Use these steps to add or remove interfaces in an ESX host environment.
1. Shut down the Brocade Virtual ADX.
NOTE
Failure to perform a shutdown prior to adding or removing interfaces, will cause unexpected
behaviour on Brocade Virtual ADX .
2. In the left pane, right-click your Brocade Virtual ADX VM and select Edit Settings to add or remove
an interface as shown in the figure below.
Additional interfaces
Brocade Virtual ADX Installation and Deployment Guide 21
53-1003241-01