Burcam 300521 HOT WATER RETENTION PUMPING SYSTEM (GENIE) - Manual (Page 2)

2
Safety Instructions :
This fine pump that you have just purchased is designed from the latest in material and workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU COMPLY
WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR SAFETY IN
MIND. BE SURE YOU COMPLY WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME ELECTRICAL
DISTRIBUTION PANEL PROPERLY PROTECTED WITH A FUSE OR A CIRCUIT BREAKER.
WE ALSO REQUIRE THAT A GROUND FAULT CIRCUIT BE USED. CONSULT A LICENSED
ELECTRICIAN FOR ALL WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER BE REMOVED.
THEY ARE SUPPLIED AND DESIGNED FOR YOUR PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE
POWER CONNECTED. DO NOT ONLY UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE
THE POWER PLUG FROM THE RECEPTACLE.
A
B
C
D
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe ends,
pipe wrench, adjustable wrench to tighten fittings, propane torch and welding material.
FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
Monthly Mandatory check-up :
1. Inspect the pump for any obvious condition that necessitates cleaning, correction, adjustement or repair.
2. Clear the surrounding area of the pump.
3. Assure that the pump is secure for proper operation.
4. Assure that there is adequate clearance from any combustible materials or stucture. Stored materials
must be kept away from the pump. Shelves or cabinet structures must not be in close proximity over
the pump.
5. Assure that the motor is securely plugged into a proper GFCI electrical outlet.
6. Test the GFCI outlet by pressing its test switch. This should prove that the outlet is energized and will trip
off to protect against a ground fault. Be sure to reset the GFCI by pressing its reset switch.
7. Determine that the plumbing can direct the water safely into the residence.
Material :
Desired length of appropriate pipes to link up the water heater to the pump and the pump to the
plumbing distribution system. The pump treads is 3/4 " NPT.
Fittings required for the piping connections.
2 Ball Valve
2 Unions
2 Shut-off valve under the sink.