Burcam 450475 EASYFLUSH TOILET SYSTEM 1/2HP 115V - Manual (Page 12)

12
Some 2" X 4" can be installed on each side of the higher section of the tank to hold the gypsum board to
finish the wall (photos 8, 9 and 10).
As indicated on photo 11, the installation flange of the toilet cabinet must be fixed directly on the plastic
of the tank. Refer to the instructions booklet on page 3 and 4 for the installation of this flange.
Now the next step, is to carve a circular opening of a diameter of 1/2" larger than a flange, at the proper
place, to be able to cover the base of the tank (photos 12 and 13).
At this step, it is the time to screw the gypsum board on the 2" X 4" and finish the installation of the toilet
cabinet by fixing same to the flange (photos 14 and 15).
The cover page 10 photo shows you the completed typical project.
STEP 6
STEP 7
STEP 8
STEP 9
PHOTO 8
PHOTO 12
PHOTO 14
PHOTO 13
PHOTO 15
PHOTO 11
PHOTO 9 PHOTO 10