Burcam 450475 EASYFLUSH TOILET SYSTEM 1/2HP 115V - Manual (Page 4)

4
Insert the four (4) fl ange screws on these holes. From the inside of the tank, install the four (4) supplied
"O" rings on the screws then, the washers and nuts. Refer to the photo C. Tighten the nuts snugly.
IMPORTANT NOTICE :
The fl ange must be set directly on the sewage tank to assure a perfect seal. Use a waterproof silicone
caulking to prevent leakage. Otherwise sewage may leak from unit, that way cause damage to property
and void warranty, due to an improper installation. When using a plywood to fi nish the fl oor area, install
the fl ange fi rst, then cut the plywood around the fl ange, leaving 1/4’’ between the fl ange and the plywood.
Install the pump in the "EASY FLUSH" unit, aligning the pump legs with the moulded cavities.
The rubber grommet fi ts to the vent hole to assure a perfect sealing. (Photo D)
The vent pipe size is 3’’. Use an elbow to connect the pipe to the tank. The length of the pipe exceeding
the elbow has to be 2 1/2’’ to 3’’. (Photo E)
Fix the pipe to the tank by inserting the pipe into the rubber grommet. Use soap to facilitate the insertion.
Push the pipe until the elbow becomes in contact with the rubber grommet. (Photo F-G)
Cut a short piece of foam seal (3 3/4’’) as the basic wire slots seal, then glue it to fi t the sloats’ shape.
(Photo H-I)
Then, cut the full length foam seal for this side of the tank. (Photo J) Glue this full length to the tank over
the previous small piece.
Using a screwdriver, make pilot holes into the foam seal to allow the bolts of the lid to reach the brass
insert. (Photo J)
STEP 6
STEP 7
STEP 8
STEP 10
STEP 9
STEP 11
STEP 12
STEP 13
"O" RINGS (4)
RUBBER
GROMMET
PHOTO C PHOTO D
PHOTO E
2 1/2’’ to 3’’
PHOTO G
PHOTO J PHOTO I PHOTO H
PHOTO F
WIRE SLOTS