Elitegroup X20II - Manual (Page 75)

■ chapter 4 upgrading your computer
The card should pop up to an angle of 30 degree.
3. Locate 2 antenna cables with connectors. Snap the cable
onto the golden connector on the wirelss mini-card. (Note: The
connectors are fairly small! This may take some maneuvering.
You may want to connect the antenna cables before inserting
the wireless card into the socket. )
4. Replace the System Device Cover and 7 Screw A’s.
Congratulations! You have now completed the wireless
mini-card installation. During the next time the system boots to
Windows, the system will prompt for driver location. Insert the
Factory CD-ROM and point to the directory where the Wireless
LAN driver can be found. In addition to installing the driver, you
may also need to run a Setup.exe program to install the card’s
utility applications before it is fully operational.
4-17