Elitegroup EZ-Buddie2 D21 I4-3 Manual - Manual (Page 23)

19
Note: Before installing an add-on card, check the documentation for the card
carefully. If the card is not Plug and Play, you may have to manually con-
figure the card before installation.
Follow these instructions to install an add-on card:
1. Remove a blanking plate from the system case corresponding to the slot
you are going to use.
2. Install the edge connector of the add-on card into the expansion slot. En-
sure that the edge connector is correctly seated in the slot.
3. Secure the metal bracket of the card to the system with a screw.
Note: For some add-on cards, for example graphics adapters and network adapters,
you have to install drivers and software before you can begin using the add-on
card.