Elitegroup EZ-Buddie2 D21 I4-3 Manual - Manual (Page 42)

38
POWER ON Function (Hot KEY)
This feature allows you to set the method by which your system can be turned
on.
KB Power ON Password (Enter)
When the POWER ON Function is set to Password, use this item to set the
password.
HotKey Power On (Ctrl-F12)
When the POWER ON Function is set to Hot KEY, use this item to set the hot
key combination that turns on the system.
Onboard Serial Port 1 (3F8/IRQ4)
Select a logical COM port name and matching address for the first and sec-
ond serial ports. Select an address and corresponding interrupt for the first
and second serial ports.
Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard parallel port.
Parallel Port Mode (ECP)
Enables you to set the data transfer protocol for your parallel port. There are
four options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port),
ECP (Extended Capabilities Port), and ECP+EPP.
SPP allows data output only. Extended Capabilities Port (ECP) and Enhanced
Parallel Port (EPP) are bi-directional modes, allowing both data input and output.
ECP and EPP modes are only supported with EPP- and ECP-aware peripherals.
ECP Mode Use DMA (3)
When the onboard parallel port is set to ECP mode, the parallel port can use
DMA 3 or DMA 1.
Power On After Power Fail (Off )
This item enables your computer to automatically restart or return to its last
operating status after power returns from a power failure.