HATZ Diesel 2G40 H - Manual (Page 17)

5.2. Maintenance work every 8 – 15
operating hours
5.2.1. Check engine oil level
When the oil level is checked, the engine must
be stopped and in a horizontal position.
– Remove any dirt in the dipstick area.
15
– For oil level inspection, remove the dipstick „2“
and wipe it dry using a lint-free, clean piece of
cloth; then insert it to its stop and pull it out
again.
– Check oil level at the dipstick; top up if
necessary as far as the „max“ mark (see
Chapter 4.1.1.).
Attention !
If the engine is operated while the oil level is
below the min. mark or above the max. mark, it
can cause damage to the engine.
5.2.2. Check combustion air intake area
Heavy contamination is an indication that in-
creased dust accumulation necessitates a corre-
spondingly shorter maintenance interval,
Chapter 5.3.1. and 5.4.2.
1
2
With oilbath air cleaner:
16
– Inspect air inlets „1“ (depending on version)
for severe dirt and dust deposits, and clean if
necessary.
– Make sure that dust outlet „2“ on the
cyclone-type dust trap (depending on version)
is not obstructed, and clean if necessary
(chap. 5.3.1.).
With dry-type air cleaner:
17
– Inspect air inlets „1“ and clean if necessary.
– Check that dust discharge valve „2“ is not ob-
structed; eliminate dust blockage by pressing
together as shown.
16