Alliance Laundry Systems Dishwasher - Manual (Page 13)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802715 13
Connecting Power Cord with Three-Wire
Plug
NOTE: Four-wire cord is required for mobile
homes or where codes do not permit grounding
through neutral.
Figure 12
1. Disconnect power to dryer.
2. Remove access cover from rear of dryer.
Figure 13
3. Use a strain relief and insert end of power cord
through power supply hole.
Figure 14
D816I
1 3 Wire Grounded Neutral 120/240 Volt, 60 Hertz
AC 1 Phase Service Entrance Switch Box
(Refer to NOTE above) 4 Metallic or Non-Metallic Sheathed Cable
(Copper Wire Only)
5 Power Cord (Not supplied with dryer)
2 30 Ampere Fuses or Circuit Breaker 6 Neutral
3 Neutral Wire 7 Terminal Block in Dryer
NOTE: The power cord is NOT supplied with the
electric dryer. Type of power cord and gauge of wire
must conform to local codes and instructions.
The method of wiring the dryer is optional and subject
to local code requirements.
NOTE: Connect the dryer to the power supply with the
MAXIMUM RATED VOLTAGE listed on the nameplate.
1
3
5
6
7
4
2
POWER CORD CONNECTION DIRECT CONNECTION
L1 L2 L1 L2
INTERMEDIATE
SHUT-OFF BOX
(may or may not
be fused)
POWER SUPPLY POWER SUPPLY
INTERMEDIATE FUSE
BOX (may be omitted
if service entrance
box is fused)
WALL
RECEPTACLE
A typical 30-
Amp Three-
Wire
Receptacle
NEMA Type
10-30R
120 ± 12
V.A.C.
120 ± 12
V.A.C.
240 ± 12
V.A.C.
NOTE: Use COPPER WIRE only.
Shorter than 15 ft. (4.5 m) – use 10 AWG
Longer than 15 ft. (4.5 m) – use 8 AWG
D695I
D696I