Alliance Laundry Systems Dishwasher User Manual
Page 9
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
802715
9
Step 4: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp and by removing the shipping tape.
Install the drain hose into the drain receptacle
(standpipe, wall or laundry tub) following the
instructions below.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-1/4 inch (32 cm) outside
diameter drain hose.
Standpipe Installation:
Place the drain hose into the standpipe.
Remove the beaded strap from accessories bag and
place around standpipe and drain hose and tighten
strap to hold hose to standpipe. Refer to Figure 8. This
will prevent the drain hose from dislodging from drain
receptacle during use.
Wall Installation:
For installations of this type, the drain hose MUST be
secured to one of the fill hoses using the beaded strap
from accessories bag. Refer to Figure 9.
NOTE: End of drain hose must not be below 24 in.
(61 cm).
Laundry Tub Installation:
For this type of installation, the drain hose MUST be
secured to the stationary tub to prevent hose from
dislodging during use. Refer to Figure 10. Use the
beaded strap (supplied in accessories bag) to secure
hose.
SWD598N
1
Drain Hose
2
Beaded Tie-Down Strap
3
Standpipe 2 in. (5.08 cm) or 1-1/2 in. (4 cm)
Figure 8
SWD598N
1
2
3
24 in. to 36 in.
(61 to 91.44 cm)
Recommended
Height
H023I
1
Drain Hose
2
Beaded Strap (tape if necessary)
3
Fill Hoses
Figure 9
SWD600N
1
Drain Hose
2
Tie-Down Strap (tape if necessary)
Figure 10
3
1
2
SWD600N
1
2