Hired-Hand Funnel Flow Fans: 36 48 & 52 Funnel Flow Belt Drive Fan Unassembled User Manual
Page 5
Part No. 4801-5401 Rev 6/07
36" 48" & 52" Funnel Flow Fan – Unassembled
Page 5 of 12
Detail A
Two washers on top
5 Tools
Required
6 Assembly
Instructions
6.1
Refer to Figure 1. Arrange the Top Brace and the Bottom
Brace as shown. Where the Braces join, line up the six
holes.
6.2
Refer to Figure 2. Locate the two pillow block bearings that
attach to the bottom of the bracket. Position each bearing
with the set screw to the outside. Align and center one
bearing with the bolt holes in the top front of bracket and the
other to the top rear. Refer to Detail A. Secure the bearing
mounts with four 5/16” x 1.5” (1004-5002) cap screws.
Insert one 3/8”stainless washer (1003-0106) and one 5/16”x
3/4"washer (1003-0103) on top of the bearing mount and
one 5/16” x 3/4” flat washer (1003-0103) from the bottom
and locknut (1001-0103) from the bottom. Do not tighten at
this time.
6.3 Tighten the two grease fittings with a 5/16“
socket.
6.4 Refer to Figures 3. Locate the Bearing Shaft
Alignment tool and place in the two center holes
over the drive shaft. The Head of the tool faces to
the rear of the Fan Brace. The tool serves to align
the bearing mounts. Tighten with ½” socket. If an
alignment tool is not available, see Detail C for
alignment measurements.
Tools Required:
Torque Wrench
½” & 7/16” Wrenches
Rubber Mallet
½”, 5/16” & 7/16” Sockets
Lock-Tite Compound
4 mm Allen Head Socket
Framing Square
5/32” Allen Head Socket
6” long 3/8” Extension
¼” &21/64”x5” Drill Bits
½” Drive (Ft-Lbs.)
3/8" Ratchet
3/8” Drive (In.-Lbs.)
3/8” Drill
IMPORTANT!
Locate packing slip and make sure that all
listed parts are enclosed. If not, call your
Hired-Hand distributor immediately. Please
read and understand all instructions in this
manual before assembling fan.
Figure 1
Figure 1
Front
Top Brace
48"&52"(0403-4889)
36"(0403-5520)
Bottom Brace
48"&52"(0403-4890)
36"(0403-5521)
Figure 2
Bearing
(1016-0100)
Set Screws face
outward
ad
Figure 3
Alignment
Tool -