Alcatel Carrier Internetworking Solutions Versatis Conference Phone - Manual (Page 29)

2.2 INSTALLING THE POD
2.2.1 Inserting the battery pack
l Open the battery compartment under the Pod.
l Insert the battery pack (7.2V 1800mAh), ensuring that the plug and connector are correctly aligned.
l Replace the battery cover.
2.2.2 Connecting the Pod to the mains
l Plug the Pod power supply cable into the socket at the rear of the Pod.
l Connect the mains adapter to a 230V / 50Hz electrical socket.
Before using the Pod for the first time, we recommend that you leave it to charge up for 24 hours in order to optimise the performance
and longevity of the battery pack.
2.3 CHARGING THE POD
If the battery icon flashes or the LEDs on the Pod flash RED periodically during a call, the Pod needs recharging.
l To recharge, plug the 230V mains adapter into the Pod. The battery is charged when the battery icon stops flashing.
l To check that the Pod is registered on the base, press to take the line.
" If you hear the dial tone, the Pod is working.
l Check that the symbol is full on (not flashing).
When the Pod battery is completely flat, it may take several minutes for the display to light up after you plug in the mains adapter.
2.4 FOR MAXIMUM PERFORMANCE
Install your conference phone in a quiet location.
Keep the Pod within 50 metres of the base.
Do not move the Pod during calls.
29
Versatis_Conference_uk.qxd 31/03/2005 16:03 Page 29