LT Security LTD831H6 - Manual (Page 20)

17
5.2.6.3 PTZ Setup
5.2.6.4 Mobile
Mobile Function
Currently operation systems compatible with mobile phone include Windows Mobile and Symbian.
Enter into [Main menu Device PTZ Setup] to select the PTZ
channel you want to control and set PTZ protocol (Pelco-D, Pelco-P),
Baud rate (1200、2400、4800、9600), Data bit (8、7、6、5), Stop bit
(1、2), Parity Check（None、Odd、Even Mark Space）and address code
respectively. Please note you could operate PTZ control only when
the above-mentioned channel parameter must be consistent with
parameter set of PTZ control.
Detailed contact method, please refer to System Configuration
and Rear Panel Outline
Picture 5-23
Picture 5-24
Click [Main menuDeviceMobile] to enter into [Mobile]
menu.
User Name: indicate user name of DVR.
User password: indicate user password of DVR
Server port: Mobile monitoring port. Setting range is between 1024
and 65535. Please note that
Explanation: Please connect DVR to Internet before setting
DVR port number and the server port no is not equal to network
menus’
Picture 5-25
Please set relative parameter of DVR and connect to Internet before mobile phone
monitoring
Explanation: Only you could proceed single channel monitoring. Transmission
code of live image is related to network transmission, and display effect related to
camera performance.
When operation system of mobile phone is based on Windows mobile, procedure as
follows:
1. Widget installation