LT Security PTZ217X12 User Manual - Manual (Page 15)

User Manual of 4-inch High Speed Dome
6
keyboards, DVRs, DVSs, etc. In this and the following chapters, operation of the speed dome by the
IE browser of a DVR will be taken as an example.
Note: Please make sure that the baudrate, date bit and address have been configured to the same
as those of the speed dome in the remote configuration interface of the control device. Please refer
to Table 2-1 for details of the configuration.
Panning and tilting:
Click the direction buttons to control the movement of the speed dome.
Zooming:
Click the ZOOM in/out buttons to control the zooming.
Focusing:
Click the FOCUS+ and FOCUS- buttons to adjust the focus.
Iris:
Click the IRIS+ and IRIS- buttons to adjust the iris.
2.3 System-defined Presets
Purpose:
The section lists the system-defined presets with special functions. These presets cannot be edited
but only called through a control device e.g. a DVS or web browser. To call the system-defined
presets remotely, you can choose the preset number from the list in the PTZ control panel. Please
refer to below table for details.
For instance, preset 99 is the “Start auto scan”. If you call the preset 99, the speed dome starts auto
scan function.
Table 2-2 System-defined Presets
Preset NO. Function Preset NO. Function
33 Auto-flip 93 Set manual limit stops
34 Return to home position 94 Remote reboot
35 Patrol 1 95 Access main menu
36 Patrol 2 96 Stop scanning
37 Patrol 3 97 Start random scanning
38 Patrol 4 98 Start frame scanning
39 IR cut filter in 99 Start auto scanning
40 IR cut filter out 100 Start tilt scanning
41 Pattern 1 101 Start panorama scanning
42 Pattern 2 102 Patrol 5
43 Pattern 3 103 Patrol 6
44 Pattern 4 104 Patrol 7
92 Enable limit stops 105 Patrol 8
Note: For Manchester code control protocol, the system-defined presets with special functions are
shown as below: