LT Security PTZ217X12 User Manual - Manual (Page 28)

User Manual of 4-inch High Speed Dome
19
TITLE
CODE
TITLE
Figure 3-9 Set Dome Title
7. Click the left/right direction buttons to position the cursor to the characters of the title.
8. Get the codes for a specific character and enter each code (number) by calling the preset
number, i.e. calling presets 1-9 to enter number 1-9 respectively, and calling preset 10 to enter
number 0.
Note: You can get the codes of a specific character using the software we provided. For example, if
you want to display the word HALL as a part of the dome name, please follow below steps:
Steps:
(1) Enter HALL in the Title filed of the software, click OK, and you’ll see the corresponding
codes 0227-0220-0231-0231 listed for it.
Figure 3-10 Get the Codes of a Character
(2) On the SET TITLE menu, call the presets standing for each code in sequence to enter the
codes. E.g. call preset 10 to get 0, and call preset 2 to get 2. The corresponding numbers,
characters and position information will be displayed on the screen when you are calling the
presets.
(3) You can call preset 16 to delete the character at the current position.
Note: You can set up to 15 characters for the dome title.
9. Exit the title setting menu and display the dome title.
You can call preset 12 twice within 5 seconds to exit the title setting menu and display the title
in the lower right corner; or call preset 13 twice within 5 seconds to exit the title setting menu
and display the title in the lower left corner; or call preset 14 twice within 5 seconds to exit the
title setting menu and display the title in the upper left corner; or call preset 15 twice within 5
seconds to exit the title setting menu and display the title in the upper right corner.
Note: After exit the SET TITLE menu, you can call preset 12 twice within 5 seconds to delete the
defined title and remove it from the screen.
 Display the PTZ movements, alarm, system time, etc.