Rhino Shelter ROUND-12W X 20L X 8H - Manual (Page 7)

Assembly Instructions Round Style 12 x 20 x 8
V2.3
Please Do NOT Return Assembly to Dealer or Store. For All questions or Shortages please call MDM Products directly
Customer Service 800-447-7079 or 203-877-7070
7
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. If pulling
them up puts too much stress on the slit where it goes
over the wind brace, use a sharp knife to cut slit another
inch or two to relieve it. The PE fabric is rip-stop weave,
and can easily be cut to relieve stress at the frame
members. MAIN COVER INSTALLATION
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle (turn-buckle should be
loosened all the way) and attach the turnbuckle to the
hole in the foot of the end arch. Hold the end of the
unsecured rope and apply downward pressure with a
foot to remove excess slack. Re-adjust gathered
material evenly along inside edge of door rope slot. This
step is key to getting a good door fit. Tie off the end off
the rope to a second turnbuckle (fully opened) attached
to a hole in the foot of the end arch on the opposite side.
The end panel can then be tightened further by adjusting
each turnbuckle.
Note: Adjust the end door panel by turning the
turnbuckles or repeating step 3 on a regular basis
Step 1. To elongate the life of Main Cover, put a small
square of duct tape (field supplied) over each bolt head
on frame that comes in contact with cover. The tape
acts as a cushion to avoid rubbing damage to the cover
over years.
After covering bolt heads with tape, unpack the Main
Cover #RUC-5000 from the protective plastic packaging.
The line of grommets on the inside (white) of the cover
on the tie Down Flap run parallel to the sides of the
frame assembly for positioning. Once cover is oriented
properly to the Frame Assembly, pull Main Cover over
top of frame assembly from the side, being careful not to
snag the cover on any member, bolt, or other
obstruction. Center the Main Cover over the Frame
Assembly with the Main Cover colored side showing
from the outside of the unit.
Step 2. Loosen the 4 remaining turnbuckles completely.
Place the turnbuckles into hole in the foot of the end
arches on the outside of the end panel. Tie off the rope
coming out of the Main Cover rope slot on either side to
the turnbuckles. After tying off one end of the rope in the
Main Cover, pull the excess slack out of the rope and
cover. Hold the end of the rope and push directly down
with a foot onto the excess rope. Temporarily tie the
other end of the rope to the turnbuckle. Go over the
entire edge of the cover and adjust the excess folds of
material around the end so it is evenly distributed around
rope slot. Once the rope is pulled tight and the cover is
adjusted evenly over frame, tie off the rope end to the
turnbuckle. All slack should be out of the rope at this
time. Tighten the turnbuckle to further tighten the cover
if necessary. Ensure the cover is centered. (this step