Anchor step 2, End panel installation, Assembly instructions – Rhino Shelter ROUND-14W X 36L X 15H User Manual
Page 6: Every arch must be secured
Assembly Instructions
14x36x15 Round RV/Boat
ANCHOR STEP 1
Step 1. Place the drive rod provided into the cup of the
anchor. Using a heavy hammer drive the anchor into the
soil until 6-8 inches of cable remains above the earth.
Remove drive rod.
ANCHOR STEP 2
Place the Drive Rod through the loop in the anchor
lanyard. Pull upward to set anchor head into the ground.
V2.2
Please Do NOT Return Assembly to Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products directly
Customer Service 800-447-7079 or 203-877-7070
6
ANCHOR STEP 3
Slip one side of the U-bolt through the eyelet at the end
of the anchor cable. Attach the cable to the Arch leg
upright with the U-bolt and tighten. Do not attach to base
cross rails. Ensure there is no slack in the cable. Slack
can be removed by wrapping the cable around the tie-
down rail.
Every Arch
MUST be
secured
END PANEL INSTALLATION
Note: End panels MUST be installed before installing
Main Cover onto frame.
Step1. Remove Carriage bolts from the Top Ridge Rail
and the two Upper Side Cross Rails. Install End Panel
Door w/Zippers (DZD-7002) one at a time to the frame
assembly. Carefully align the door material evenly over
the arch to make an even fit.
Step 2. Place the end panel over the first arch and wrap
the material over the End Arch bringing the slits in the
end panel to the inside of the frame. End Door Panels
have pre-cut slots that allow frame members to pass
through so rope pocket is inside unit. Remove the cross
rail and top ridge bolts one at a time to put the door
panel over the end arch members. Place the top ridge