Rhino Shelter ROUND-14W X 36L X 15H - Manual (Page 7)

Assembly Instructions 14x36x15 Round RV/Boat
rail pole and the side cross rail poles through the
material slits and replace the carriage bolts and tighten.
Each door end will also require removal of the wind
brace bolts and placement of the wind braces through
slits in the ends panel. Reconnect wind braces with
carriage bolts once end panel is put into place.
V2.2
Please Do NOT Return Assembly to Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products directly
Customer Service 800-447-7079 or 203-877-7070
7
The rope slot should be located inside the unit, with the
frame members passing through the pre-cut slots in the
end panel/door. Replace the carriage bolts after putting
the end panels into position.
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. If pulling
them up puts too much stress on the slit where it goes
over the wind brace, use a sharp knife to cut slit another
inch or two to relieve it. The PE fabric is rip-stop weave,
and can easily be cut to relieve stress at the frame
members.
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle (turn-buckle should be
loosened all the way) and attach the turnbuckle to the
hole in the foot of the end arch. Hold the end of the
unsecured rope and apply downward pressure with a
foot to remove excess slack. Re-adjust gathered
material evenly along inside edge of door rope slot. This
step is key to getting a good door fit. Tie off the end off
the rope to a second turnbuckle (fully expanded)
attached to a hole in the foot of the end arch on the
opposite side. The end panel can then be tightened
further by adjusting each turnbuckle.
Note: Adjust the end door panel by turning the
turnbuckles or repeating step 3 on a regular basis
MAIN COVER INSTALLATION
Step 1. To elongate the life of Main Cover, put a small
square of duct tape (field supplied) over each bolt head
on frame that comes in contact with cover. The tape
acts as a cushion to avoid rubbing damage to the cover
over years. As an alternative, foam rubber pipe
insulation makes a good cushion between the bolt heads
and the main cover as well.
Turnbuckles
Side Cross Rails
Top Ridge Rail