Rhino Shelter ROUND-14W X 36L X 15H - Manual (Page 9)

Assembly Instructions 14x36x15 Round RV/Boat
V2.2
Please Do NOT Return Assembly to Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products directly
Customer Service 800-447-7079 or 203-877-7070
9
Snow Accumulation – All snow accumulation on the
main cover should be removed as soon as possible.
Tap the main cover from the inside with a broom or soft
brush to clear cover. Unit is not designed for any
amount of accumulated snow or ice. Warrantee does
NOT cover damage due to snow accumulation.
Main Cover Lacing – the poly rope that secures the main
cover to the bottom rail of the frame assembly should be
checked, and adjusted as needed. The tension on the
main cover should be uniform from end to end and side
to side. Rope ends must be tied off onto the frame
members at the ends on each side.
Turnbuckle Adjustment – during normal wind conditions
and load, the doors and main cover adjustment points at
the turnbuckle should be checked and tightened as
necessary. The turnbuckles should be neither
completely extended nor taken up, so that turnbuckle
should be tight when in the mid range of overall
adjustment. If necessary, readjust rope tie off on
turnbuckle as needed to tighten or loosen as needed.
Cleaning – cover and doors can be cleaned with a
mixture of light detergent and water. A soft bristle brush
with the mixture can be used to loosen any hard dirt,
mold, or buildup on the cover. After cleansing, the cover
should be rinsed thoroughly to avoid any chemical
reaction from residual detergent. Allowing dirt and
debris to sit on cover over an extended time will damage
cover irreparably.
Severe Weather – in preparation for inclement weather,
completely secure the doors on both ends of your Rhino
Shelter portable building. Allowing wind to enter either
end lifts the building and puts undue stress on the
anchoring system. This also shortens the life of the
doors, zippers, and main cover.
Door Operation – Every time doors are put down the
zipper must be pulled down completely, and the snap
buckles MUST be put together and adjusted. Failure to
do so will cause door zipper to fail prematurely. Door
area is so large that wind can pull zipper apart if the
snap buckles are not adjusted to take the stress of wind.
CUSTOMER SERVICE AND ASSISTANCE
Please call MDM Products at 800-447-7079 or 203-877-
7070 for questions about the proper installation of the
unit in any way. Care and attention to a proper
installation will add many years of life and function to
your Rhino Shelter unit.
Please retain purchase documentation for your Rhino
Shelter unit. All warranty claims must include purchase
documentation for verification. All parts on your Rhino
Shelter unit are available for replacement as needed.
Protect your purchase by completing warranty
registration card and mail/fax as soon as practical after
installing your unit.
Thanks again for choosing this quality product. With
proper operation and care we are confident it will meet
your expectations in functionality, appearance and
longevity.