RIKON Power Tools 10-308 - Manual (Page 9)

9
Assembly
Leg Assembly
To assemble the legs proceed as follows.
 Set the main saw body on its side.
 Gather up the following parts:
a. Legs (4)
b. Hex Head Bolts (16)
c. Hex Nuts (16)
d. Rubber feet (4)
 Slide the legs in the bottom slots and align holes.
 Attach 2 legs using the bolts and hex nuts provided by lin-
ing up the leg holes with the holes in the lower saw body.
 Roll the saw over , attach the other 2 legs and 4 rubber feet.
 With help lift and tilt the bandsaw to its upright position.
Table Assembly
 To attach the sliding table you need to gather up:
a. Sliding Table
b. Cover Plate
c. Front Slide
d. Rear Slide
e. Cap Screws (2)
f. Carriage Bolts (4)
g. Acorn nuts (4)
 Align the Plate Cover with the holes to the top of the saw
base by the column.
 On top of the Plate Cover align the Rear Slide (A) to the
same holes.
 Notice the rails extend over the front of the saw in the oper-
ating position.
 Secure both the Plate Cover and Rear Slide using the car-
riage bolts and acorn nuts. Run the carriage bolts up from
underneath the saw body with the acorn nuts on top.
 Attach the Front Slide (B) using the carriage bolts and
acorn nuts provided.
 You will have to remove the 4 hex bolts and table alignment
brace to slide the table past the blade.
 Place the Sliding Table onto the rails so the bearings can
slide back and forth smoothly. You might have to adjust the
slides a little for smooth travel. Slide the table as far forward
as it will go without allowing it fall off.
 Re-attach the table alignment brace you took off to the back
end of the sliding table using the 4 hex head bolts and flat
washers provided.
 The 2 cap screws are used as stops for the table. First
screw on 2 hex nuts to each cap screw.
 Position the cap screws onto the underside of the table as
shown and affix using 2 more hex nuts.
 Adjust nuts on cap screw so table stops.
A
B