Operation – RIKON Power Tools 25-010 User Manual
Page 13
Operation
To increase the depth of cut simply rotate the infeed
adjustment knob anticlockwise Fig.5.5C.
6.4 Jointing:
For jointing the narrow sides of a workpiece release the
blade guard lock lever and set blade guard to width of
workpiece. The plastic spring on the end of the blade
guard should exert a slight pressure against the work-
piece. Lock blade guard in place and start the machine.
Push workpiece slowly and steady against cutter block.
Ensure that fence is set at true 90° (or any other angle
required – see Assembly – Adjusting Fence) and work-
piece is kept flush against fence Fig.5.6.
After straightening side 1, turn the workpiece 90º so
that side 1 now lines up along the fence. Surface side
2 at 90° in order to carry out thicknessing: this way it is
possible to obtain a finished piece planed on all 4 sides
Fig.5.7A.
Fig.5.6
Fig.5.5C
Adjustment Knob
Fig.5.7A
1
2
Fence
90º
1
Infeed Table
13