RIKON Power Tools 25-010H - Manual (Page 11)

11
ASSEMBLY
FIG. 13
FIG. 12
OUTFEED TABLE INSTALLATION
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
1. Position the outfeed table onto the left end of the ma-
chine frame. The two Setting Brackets (#158) fit over the
pre-installed Pan Head, Location Screws (#160) on the
frame for positioning, and then lock the table in place with
the Levers (#233, 234). FIG. 12 & 13.
2. See page 12 for instructions on adjusting the table.
JOINTER FENCE INSTALLATION
1. The Fence Carrier Support Bracket (#240, FIG. 14, A)
has been pre-installed onto the rear side of the infeed table.
2. Slide the Fence Assembly onto the Fence Bracket and
the secure it in position with the Ratchet Lever (#217).
3. See page 13 for instructions on adjusting the fence.
FIG. 14
ADJUSTMENTS
Continued on page 12
JOINTER TABLE ALIGNMENT
For the best surfacing of workpieces, the jointer’s infeed
and outfeed tables must be set at the same level to form a
large ‘flat’ surface. These tables must also be in alignment
with the cutterhead for true surfacing, when you measure
the flatness of a board from side-to-side and end-to-end.
The machine has been factory set before shipping - the in-
feed table being set to the cutterhead knives, and then the
outfeed table set to the infeed table. But once the machine
has been set in its final location in the shop, the table align-
ments should be checked to make sure that there has been
no movement during its handling.
LOCKING LEVERS
SETTING BRACKETS
LOCATION SCREWS
RATCHET LEVER
A