RIKON Power Tools 30-100 - Manual (Page 7)

Unpacking and Clean-up
1. Carefully finish removing all contents from shipping carton. Compare contents of the
shipping carton with the list shown on page 5. Place parts on a protected surface.
2. Report any shipping damage to your local distributor. If parts are missing contact
RIKON customer service at 877-884-5167 or [email protected].
3. Clean all rust protected surfaces. Do not use; gasoline, paint thinner, mineral spirits,
etc. These may damage painted surfaces.
4. Set packing material and shipping carton to the side. Do not discard until machine
has been set up and is running properly.
7
1. Install the column to the base using the three
column mounting bolts. (Fig.01)
2. Next install the table lock handle through the
unthreaded hole on the left of the table
support casting. The handle should engage
the thread on the right side of the table
support casting. (Fig.02)
The machine must not be plugged in and the power switch must be in the OFF position
until assembly is complete.
Assembly
Fig.01
Fig.02
Tools Required for Assembly
Item Description
Phillips Screwdriver
Adjustable or 13mm Wrench