RIKON Power Tools 30-120 - Manual (Page 12)

A
B
12
SETTING THE SPINDLE LOCK
1. Loosen the depth stop collar lock (A-Fig. 25)
as shown.
2. Lower the spindle to the desired depth. (Fig.
26)
3. Turn the depth stop collar clockwise until the
collar stops (B-Fig. 25).
4. Tighten the depth stop collar lock.
Figure 25
Figure 23
Figure 26
CHANGING SPINDLE SPEEDS CONT.
Figure 24
NOTE:
SETTING THE DRILL DEPTH
1. With the spindle in the up position, loosen the
depth stop collar lock (A-Fig. 25) as shown.
2. Turn the depth stop collar clockwise until the
pointer reads the desired drill depth on the
scale (B-Fig. 25).
4. Tighten the depth stop collar lock.
6. Place the belt on the pulleys in relation to the
speed chosen on the speed selection chart
starting with the motor pulley first. (Fig. 23)
7. Push the belt tension handle backward on the
motor until there is approximately 1/2"
deflection in the belt. (Fig. 24)
8. Tighten the belt tension lock handle.
9. Close the belt guard.
10. Reconnect the Drill Press to the power.
Figure 26 shows the spindle in the locked po-
sition.