Assembly – RIKON Power Tools 30-120 User Manual

Page 7

Advertising
background image

7

Figure 3

Figure 4

Base and Column Assembly

1. Place the base (A-Fig. 1) on a level floor where

the machine will be used.

2. Attach the column (B-Fig.1) to the base (A-Fig.

1) using four M8x20 hex bolts. Tighten all four

bolts.

3. Using an allen wrench (C-Fig. 2) remove the

column collar (D-Fig. 2) as shown.

4. Insert the worm elevation gear (E-Fig. 3) into

the table support bracket (F-Fig. 3) as shown.

5. Place rack (G-Fig. 4) inside the table support

bracket (F-Fig. 4) lining up the teeth as shown.

6. Slide the table support and rack assembly over

the column and replace the column collar.

C

D

Figure 1

Figure 2

Assembly

B

A

Head Assembly

1. Place the drill press head (A-Fig. 5) onto the

column (B-Fig. 5) as far as it will go.

Assistance is needed for this next step.

B

A

Figure 5

NOTE:

Advertising