RIKON Power Tools 34-250 - Manual (Page 12)

Operation
1. Mark your mortise depth on the side of your
workpiece. The depth of the mortise should
be set to the chisel point, not to the tip of the
drill bit. The extra depth cut by the drill bit will
allow room for excess glue.
Fig.15
This manual is not a training aid. There should be some basic understanding regarding
operation prior to using a mortising machine. Tips on usage can be found in books,
researching the internet and other resources.
2. Set the depth stop while holding the chisel at
the desired depth. Loosen the lock handle
(A-Fig.16). Next, lower the depth stop rod
until it makes contact with the top of the
column casting (B-Fig.16).
Fig.16
A
B
12
3. Place the workpiece against the fence. Move
the fence forward and center the chisel with
the mortise to be cut. Lock down the fence
(A-Fig.17) then position the hold down on top
of the workpiece. Lock the hold down
(B-Fig.17). Start the mortiser and feed the
chisel into the workpiece. Feed the chisel to a
depth of 1/2” then retract to allow the chips to
clear. Allow the chisel to do the work. Do not
force the cut or the motor will slow down.
Fig.17
A
B